FuzzyBot: Importing a new version from external source

2025-01-08T11:00:57Z

Importing a new version from external source

New page

# Run MuhRO as usual.
# Check that the '''Public''' chat messages are enabled in your chat settings. If not, enable them.
# Use the <code>/hoai</code> command ingame and check the message it sends to the chat:
#* OK: "Homunculus has been customized." If you see this, your game client is now set up to load the custom AI, move on.
#* Not OK: "Homunculus has been activated with the basic AI." If you see this, your game client is now using the basic AI. Use the <code>/hoai</code> command again to switch to the custom AI.
# Only after you have verified that your client is set up to load the custom AI: use the <code>@refresh</code> command ingame to reload the AI settings. (<code>@refresh</code> is not an AI command but it reloads the AI files as a side effect).
# The custom AI bundled with the MuhRO client is set to autoattack by default. If you find out that your homunculus does not autoattack, make sure it is not in standby mode:
#* Heal your homunculus to full HP.
#* Use Warper - Dungeons - Anthell. Normally the homunculus should automatically start attacking the ant eggs near the entrance.
#* If the homunculus does not attack, use the '''Alt+T''' hotkey to switch between active and standby modes. Do not expect it to switch immediately, allow a few seconds until the homunculus becomes aware of the mode change.

Translations:Homunculus/18/en - Revision history

FuzzyBot: Importing a new version from external source